I am trying to generate cross slope report @ 10 m interval by station base or station offset report but i am not getting appropriate values of cross slope in report. It seems correctly in cross-section view. Am missing something ?? Images is ready for…

All, Was wondering if any of you have ever experienced this. I am in the IDOT (Illinois Dept of Transportation) workspace. As shown below, in my template library, the aggregate is modeled with feature definition. Whilst, in Cross Section Viewer and…

I have an issue with the tool Profile From Surface for a complex element combining multiple ditch line and not sure if this is how it was intended to work or I'm just doing something wrong. The profile draws normally until it reaches an area where the…

Hi, I am running GEOPAK SS4 and have multiple corridors in one file and when I run the cross section view modeler, all of the corridors are ran and show up in the cross sections. I am wondering if it is possible to turn off individual corridors without…

I noticed an issue with end conditions not tying into the existing ground line drawn in cross section cells. The problem occurred at several cross section and the error varied between 0.01' to upwards of 2'. After troubleshooting, it was noticed that…

When I move or delete transitions or template drops in a corridor, the tie-in slopes are remaining. When I extend a different template drop into the area where the deleted template was, there appears to be a conflict (see second screenshot). I've tried…