I merged two surfaces together to create the existing surface for my design. Upon cutting cross sections I see that both surfaces are displayed instead of just the merged surface. I'm new to OpenRoads (2020 Release 3). Is this caused by the way I merged…

I'm working on a project that features a station equation and have created a corridor for it. When I cut cross sections everything runs great up until the station equation. After the equation my proposed cross sections cut from the DTM my corridor…

I have been looking for this for a long time, and now it's time to ask the question to the people who might know the answer. I work with several seabed DTMs and often create profiles to view vertical shifts. Mostly I have one design survey with lots…

I can't seem to get proposed cross section elements to draw on my existing ground cross sections. I run the process and it works through the cross sections but draws nothing. Any solutions? A colleague in another office was able to do it, so I am assuming…

I have a project that requires a curb along most of the alignment and sidewalk replacement behind said curb in certain areas. Right now I have the sidewalk targeting a feature and I have display rules set up so that it only displays when SW feature is…