I am trying to apply an end condition exception to a template that has a right outside edge of pavement that is controlled by a horizontal feature constraint so the outside edge of pavement is able to vary (for example, at a turn lane taper transition…

Hello, I am trying to set a shoulder rollover lock for the shoulder on the highside of a superelevated section. The lane transitions from NC @ 2% to Full super at 5%. I want the slope on the left be 3% when the lane reaches full super. I have tried…

I am modeling 3D elements which were previously placed based in their corresponding X Y coordinates at elevation 0. Now that we have the terrain model I need to raise all of these elements to their corresponding elevation defined by the new terrain. Is…

I have a null point that displays a curb in my template with a horizontal feature constraint to that searches for the selected feature definition. I created a horizontal feature from a series of regular microstation lines chained together using microstation…

I have a template that has an end condition on the left and the right. This particular end condition targets a specific feature definition both horizontally and vertically. The issue is that if I have a targeted feature on only one side of the road, both…

When are we going to be able to graphically edit the superelevation control lines in Openroads? This needs to be resolved. Terry

When creating horizontal or vertical civil geometry we should have a toggle that will retain or not retain the "design intent". Having to go back and remove constraints and "re-civilize" elements is just a lot of extra clicks. Further design intent, and…