I am trying to apply an end condition exception to a template that has a right outside edge of pavement that is controlled by a horizontal feature constraint so the outside edge of pavement is able to vary (for example, at a turn lane taper transition…

When running templates with trigger lines in ORD, I am finding that I cannot have trigger lines on both sides of a corridor that search for the same feature definition. An example would be using a trigger line that starts left of the center of my template…

Hi I am using openroads 2021 Release 2. I lock the corridor once the edits are done to avoid it processing. But whenever i open dynamic cross sections view, the corridor gets processed. The time taken to process is much larger than the time taken…

Hello All. Running 2021 R2. I've modified a KYTC template for my project. The template uses "switch points" to control whether the end condition and sholder is displayed (for use at intersections, entrances, etc.). My corridor is set up and I used the…

I have some cut and fill lines that have appeared in my corridor model. I am unable to delete this line and it remains after deleting my template drops in the area. The first photo shows the area with my corridor and template still there. The photo…

I am trying to generate cross slope report @ 10 m interval by station base or station offset report but i am not getting appropriate values of cross slope in report. It seems correctly in cross-section view. Am missing something ?? Images is ready for…

I have been facing a problem with super elevation for some months now. The Alignment , corridor and superelevation are in different files. More often, the corridor file does not reflect the super elevation. The point control window in Corridor objects…

Hi All, Hoping to have some advice on the following. When i run through the prompts of calculating super elevation once this has completed, nothing seems to apply to my lanes, nor does anything appear in my super elevation editor or superelevation viewer…

Hello, when I reprocess my corridor, the superelevation definition disappears. I've defined my superelevation in other file, then I've referenced it into my model file and I've assigned to my corridor. So far everything is correct, but when I reprocess…

The above picture show the problem I'm facing. Is there a way to make ORD apply the 3% based on the modified point instead of the original?

My template is set up with priorities to solve for several cut and fill conditions. The guardrail end condition has the highest numerical priority and solved last. Naturally, this creates "pockets" of the guardrail shoulder condition along a corridor…

OpenRoads designer CONNECT Edition Version 10.07.01.32 I deleted a corrido, but the barriers remain. I tried everything I can to delete it(including DROP ELEMENT and DELETE both in 2D and 3D models) .Is there anything I can do now to erase it and rescue…

Hello all, Every time I add a clip reference the corridor seems to crash into itself.