ORD 10.12.2.4 suppose you're in dgn file "A" attach a dgn file "B" that has a horizontal alignment with an active vertical. While in file "A" you can create a profile window for the alignment shown in File "B" and you'll see file "B's" vertical geometry…

I am attempting to profile the gutter line for an intersection return. One one end of the return I want the profile to match the existing gutter line, and on the other end of the return I want the profile to match the proposed gutter line from my corridor…

Hi Guys, I cant figure out how to correct station intervals in my production profile sheet . After using chainage equation, ahead station of my profile showing unevenly. Regards , Lalit

For some reason, I cannot get my profile to display. It starts out like the first picture then i had to zoom in (a lot!) to get to the station range of my alignment as in picture 2. It use to show up with the entire proposed profile and ground line. if…

I am using OpenRoads Designer CE 2021 Release 1 for an urban roadway project that utilizes a lot of custom Civil Cells for driveways. Today I deleted one of the driveway Civil Cells and replaced it by using new reference graphics. Everything seemed to…

I have a dgn file containing an alignment with vertical geometry referenced into a work file. I would like to create a profile of the geometry in my work file, the problem is that the profile view only shows the vertical geometry. It does not show a line…

How Can we Track the level difference between two Line in profile e.g. Ground Level line and Design line or between any two profile line in Open roads like we can track during the Vertical design in MX road.

I have a wide top of pavement surface and I want to drape about 50 linear feature lines to that surface. I am trying to drape lane lines, breaklines, island outlines and pavement lines to that surface. With ORD I can create a profile from surface several…

I have the following data in ESRI shap file (.shp, .dbf) pipe data with up node, down node, up invert, down invert, diameter, shape man hole data with lid elevation, bottom invert and shaft diameter Can anyone help me with the steps to…