Roadway Designer - pavement warping vs. superelevation
I am new to Geopak Corridor Modeler and am struggling with superelevation. Actually, pavement warping would be a better description. I have stations and cross slopes at exact locations for how we want the pavement to tip and where; at the beginning of…
Re: Template and superelevation
When you have your "template1" open in the template editor, click the "Test" button down in the lower right. You will get a message that says "Warning: this template has end condition priority conflicts."
You'll need to go through each…
Template point not available as super range point
I have a pretty simple template that I'm using. It's very similar to a ramp typical where the BL is along the Left edge of the travel lane and I want to use the Left edge of my shoulder (LEOP) as my left range point when setting up superelevation control…
Re: inroads: superelevation (profile annotation)
![Jason W. Smithey [Bentley Civil]](https://communities.bentley.com/cfs-filesystemfile/__key/communityserver-components-imagefileviewer/communityserver-components-avatars-00-00-00-21-72/4TFHLUWQ3890.jpg_2D00_24x24x2.jpg?_=636515530586704343)
Piotr,
Do you have Display Positive and Negative Superelevation toggled on the Superelevation leaf of the Annotate Profile command?
Thanks,
Jason Smithey
Re: Cant Alignment
Jasmin,
What you are seeing there is the “old” Superelevation name. In past versions of InRoads, the Superelevation was stored with the alignment and not with the corridor. Unless you are using Bentley Rail Track and assign point controls to that…
Re: Inroads XM: Runoff lengths are wrong
Thanks for your time helping me with this Thomas,
I figured out that setting the Maximum Delta G value is essential. This value should come from AASHTO2004 table 3-30, and is 0.44 for my road, not 1.0. I had disregarded it because I wasn't sure…