Hi guys, I am doing some training for some of my overseas colleagues, they are used to work in Civil3D, and I am telling them all how fantastic Powercivil is. Everything is going well until one of the students asks "how can I see the contours of my…

Hi, I don't fully understand the option 'Draw Depressions Couterclockwise' under the Advanced tab in the View Contours box. Why and when should this be used? Jean Castro

I am trying to find existing slope conditions along a 280 mile corridor. I need locations where a 5% and 3% slope exist within 100ft of the track CL (rail). Is there anyway that I can set up some type of filter that will highlight the area where these…

Hi, I am having a problem with a large dtm derived from LiDAR data. It is about 350MB in size, and when I try to generate contours in either InRoads XM or v8i, I get an out of memory (swap device may be full) error. I was actually able…

i have an existing surface (dtm) and i am putting in a proposed concrete pad at a certain elevation. i want the pad to tie into the existing ground at 2 to 1 how do i generate a new proposed surface showing the 2 to 1 slope .

Hello there, I just have a simple question, is there any way that we can choose another method of smoothing of Contours in Inroads , for example in Geopak we have more than one one method of smoothing as shown below: Thanks...