• Revision History (https://communities.bentley.com/products/ram-staad/w/structural_analysis_and_design__wiki/6555/revision-history)

    Royal Civil Design Center
    Royal Civil Design Center
    Upto STAAD.Pro ( CE V22 Update 5 ) Revision History Column is very impressive in terms of categories. But in CE V22 Update 7 (current release) and CE V22 Update 6 is replaced by
    • over 2 years ago
    • RAM | STAAD | ADINA
    • STAAD.Pro
  • HOW TO DESIGN A SLANT BEAM (INCLINED RAMP BEAM) IN STAAD PRO C.E WORKFLOW

    Joseph Lucas Magare
    Joseph Lucas Magare
    Iam interested to know if i can design a slanting reinforced concrete beam as shown in figure below, and perform its deflection check. This can not be done in RCDC because RCDC design beams at a constant height
    • over 2 years ago
    • RAM | STAAD | ADINA
    • RAM | STAAD Forum
  • RC PLATE DEFLECTION IN STAAD PRO CE

    Joseph Lucas Magare
    Joseph Lucas Magare
    Iam designing a concrete slab supported on two beams,the deflection results obtained in staad pro (post procssing) are given in length unit,how do i compare these results with allowable deflection because the alowable deflection according to BS 8110 …
    • over 2 years ago
    • RAM | STAAD | ADINA
    • RAM | STAAD Forum
  • WALL TANK DESIGN (WALL MATERIAL STEEL PLATE) IN STAAD PRO

    Joseph Lucas Magare
    Joseph Lucas Magare
    I have a wall tank to design, whose wall material are steel plate of 12mm.I have performed analysis but when it comes to design on assigning design property there is no option to assign parameter on plates only beam, i need a help on this
    • over 2 years ago
    • RAM | STAAD | ADINA
    • RAM | STAAD Forum
  • I NEED A HELP ON HOW TO CREATE A HOLE IN A BEAM STAAD PRO CONNECT EDITION

    Joseph Lucas Magare
    Joseph Lucas Magare
    I need a help on how to create a hole in a beam?
    • over 2 years ago
    • RAM | STAAD | ADINA
    • STAAD.Pro
  • STEEL ROD AS BRACING IN STAAD PRO CONNECT EDITION

    Joseph Lucas Magare
    Joseph Lucas Magare
    I have model my truss and i want to add steel rod of 20mm diameter as a bracing on pipes carrying the truss,is this option available in Staad Pro Connect Edition?
    • over 2 years ago
    • RAM | STAAD | ADINA
    • STAAD.Pro
  • View related content from anywhere
  • More
  • Cancel