Hello, Guys!
Is STAAD.Pro has this efficient transfer of force from a wide flange used as a column to a concrete pedestal both designed in a single file? Or do I need to model them separately?
Another question: How can I represent a bearing…
Hello Everyone !
I Have Done Analysis For Window Model Using Prismatic General Section.
But While Generating Report , No Property Values i.e. Ixx, Iyy, Izz For Prismatic Section Were Displayed in Utilization Ratio Table.
Please Suggest How to get…
Dear All,
I got lot of warnings for the beams that the compressive axial stress in member exceed 0.08fck. What is the solution for that i have got lot of warnings regarding this. Please suggest me
Thanks & Regards,
Anirudh
PDF
Dear communities,
Please provide me the solution or method to design & analysis the STEPPED column.
For the reference, I have attached the pdf file, please check it & provide me the solution.
Thank you.
Hello Everyone
For a while, I was using an Advanced Concrete Design (RCDC) for the design of a solid slab. Today I tried to learn the RAM concept for the slab designs but I saw a design of strips that had never seen before (When I was using RCDC and…
Hello , I have done analysis and tried RC designer . the columns are safe. Beam summary show fails. please help me into this . cross section of beam is large i assume.
8284.COLLEGE PROKECT.STD
I am using Member loading ( UDL ) and getting warning in the analysis output, which for me seems like a software bug, can you please guide me.
Input
LOAD 20 WIND: WIND X
MEMBER LOAD
13 UNI Y 3.28 0 3.25 0
I have give f1,f2,f3 and f4 as the manual…
Hello,
I am new Civil Engineering graduate that is working on the design of electrical substations. I am currently modelling a structure simple structure where I have two horizontal beams that are connected to each other by a plate. On top of the plate…
We have a issue,
We prepared a design to our client in tender stage.
Same model now when it is analysed in Staad connect there are failure messages (below is the screen shot).
PDF
There are many beams with this failure message,
Can you let…