See attached STAAD files. At node 3, the deflection is way too high and I can't find the reason. I suppose there's an issue since beams 5,6,7 and 12 are one member, but is bent. Not sure who do models this without causing issues ! Suspended_Bentley.S…
Applies To
Product(s):
STAAD.Pro
Version(s):
ALL
Environment:
ALL
Area:
Modeling Solutions
Subarea:
Geometry
Original Author:
Modestas Turulis, Bentley Technical Support…
Hello Everyone
For a while, I was using an Advanced Concrete Design (RCDC) for the design of a solid slab. Today I tried to learn the RAM concept for the slab designs but I saw a design of strips that had never seen before (When I was using RCDC and…
Hello Everyone.
I create a dummy beam with density=0 and E=0 (Figure.1) then I assign the beam (Figure.2) then Staad Error occurs( ***ERROR*** MATERIAL NAME MUST NOT CONTAIN ANY BLANK SPACE )(Figure.3), What is the solution?
Mark your calendar and invite your colleagues to the next STAAD Special Interest Group virtual workshop on Thursday, January 24, at 1 p.m. EST. We will discuss Modeling Floor Diaphragms in STAAD.Pro CONNECT Edition . Register now!
This complimentary…
Applies To
Product(s):
STAAD.Pro
Version(s):
CONNECT Edition
Environment:
ALL
Area:
General Solution
Original Author:
Sye Chakraborty, Bentley Technical Support Group
…
Join Bentley's Sabrina Tedeschi online Thursday, September 21, 2017 for the next STAAD Special Interest Group (SIG) workshop, Interoperability of STAAD.Pro CONNECT Edition With Integrated Structural Modeling . The one-hour session starts at 1 p.m. EDT…