Errors/Limitations: 1. Spacing between Double Angle is giving erroneous output in Steel Autodrafter, even if the units are same for both the cases. 2. Steel Autodrafter generates drawings for separate views along with Section Chart & Bill of…

I noticed that steel auto drafter does not show the correct working point of beams. As seen below, WP is set at 1m from EL.2.05 which should place it at EL.3.05 however this is not the case if dimension is measured in the generated drawing. Please advise…

Dear Team Bentley, I have a curious question to ask regarding Member Size in Properties for Tapered Sections. My queries as below: 1. Why STAAD show Tapered Section with 1,2,3 etc. instead of Member Sizes like (d1-d2)xtw+2*(b1-b2)xtf1/tf2 like this…

error while opening staad file in steel auto drafter