I've searched the forum for any recommendation regarding best camera angle when collecting photos for both orthophotos and 3D-models with a drone. In other forums I may find recommendations spanning from minus 30 to minus 80 degrees from horizon but they…

I've been searching the forum and read all the manuals avalible for Context Capture Master and the process of aerotriangulation and productions of orthophotos. But I'm still uncertain on how the process should be conducted in order to achive best result…

I'm desperately searching for a page I've recently seen on the forum (or was it the Wiki?), describing the maths and process on how to determine a good distance between GCP;s on a large land survey project. - Is there anyone out there who know what…

We collect thousands of photos from our municipality with our little drone and our goal is to create survey grade ortophotos and a presentable 3D model for the web. When adding the photos to Context Capture I assume camera data would be the same for all…

We're collecting photos with our DJI Mini 2 for the purpose of creating ortho-photos and/or 3D-models. We're flying at 100m and overlap typically 80/75% to get a final resolution of approximately 2-3cm/pixel. Multiple GCP;s are spread around the project…

So the issue I'm having is incomplete photos. Photos Positioning Level: Georeferenced. what is the best way to fix this? also I'm using the DJI P1 what is the best way to get the data from the photos so I can update the image positioning? I tried…

I have photos from an XT2 that I can't get to process. There must be some trick to it that I can't figure out. We flew the site at 90% overlap and it looks like there is plenty of overlap but they will not process. Do I need accurate camera/lens properties…

Hi all, We have an issue where our X7 is completely unusable at any ISO setting of 800 or higher. The photos are blurry and look to have a 'smear' like effect all over them. DJI claim this is high iso noise but I dont think thats correct, as there is…

Hi all, I cannot figure out how CC actually apply spatial reference systems. I try to be as clear as possible with this following example: last week we surveyed an industrial site (8 hectares, a total of about 50 GPixels, 2500 images more or less…

Hello, Does CC support D-RTK GNSS by DJI A3 series flight controllers ?? The reason I'm asking is simply...normally we use control points for our aerial imagery but this time we want subcontractor to do the hard work and provide us with aerial photos…