Hi all. In composite steel girder bridges with concrete decks (continuous span bridges), does RM bridge automatically Calculator effective width of deck to calculate short-term and long-term composite cross-sections? best regards.

Hi all. I hava some question about steel composite brige as follows: 1. To calculator stress point of section, Rm Bridge automatic use short-term section for live load and load case type Non-permanent and use long-term section for load case type Permanent…

Hello, I have a problem in the beam section analysis. I assigned rebars to the beam but the program says I have "0 Ast_prvd" at the transfer location and I want to know if there is any way to fix this or if there is a special setting I should look for…

Hi, I am trying to Model a Steel bridge in OBM (Not too worried about analysis, just need a 3D model). Need to find out the best workflow. There are mainly 3 Questions . (Refer to the images below) 1. What type of Bridge I should pick at the…

I have looked everywhere and can't find a clear explanation of the mechanics behind when it will and won't apply the beam definitions. Apparently the pattern is acceptable, there were no errors when creating that, but the first 3 or 4 spans, the left…

hello Everybody! At this time! Can you help me? How to draw " this member " of Arch Bridge in Rm-Bridge? Note: only is red lines in the picture.

How do I modify the beam template to have skewed ends as detailed by TxDOT for skewed bridges? Currently, the beam ends interfere with the abutment backwalls. ftp.dot.state.tx.us/.../igebsts1.pdf We do not want to put the beams on a skew but rathre…