I need to change the stress limits for the bent cap from normal exposure (=0.19 sqrt(fc) <0.6ksi ) to severe exposure (=0.0948 sqrt (fc)<0.3ksi)

When running analysis with and without P-delta I noticed there is a substantial increase in the axial column force when P-delta is applied. At the node 1 the difference is about 300 kips. What could be a reason for such an increase? Any insight is appreciated…

I have bent that is being constructed in two phases so some shrinkage will happen on the first phase before the next phase is constructed. In the final condition, I could assume the entire shrinkage strain is applied to both sections but that will be…

Hi, There are cases where centrifugal forces produce a moment that actually counteracts the critical moment in the column, does RCPier consider effects due to vehicle cases without centrifugal forces as provisioned in AASHTO Spec (See below excerpt…

When checking Show P-delta Effects in the Analysis tab, are the values shown represent values with p-delta effect? For example, are the column/shaft moments magnified with p-delta factor in these load combinations (with a "C" on the end of the LC#)? If…

Hi All I am modelling and designing multi column pier in Leap, But after applying loads i am getting ambiguous bending moment, also huge reinforcement is showing on designing. Please find the model attached and any one please can help and check the…

I am using Leap Bridge Enterprise v14.00.00.09 in a Win7 environment. When I open the Geomath and Conspan modules, they work fine. When I open RCPier, it gets to a screen which says "Loading Project File" and then crashes, and it sometimes gives me a…

We are working a substructure design in which, due to the geometry of the roadway, it may be necessary to have the column rotated at an angle from the orientation of the pile footing on which it sits. In the past we've had to handle this via calculation…

In RC Pier, is it possible to apply a load factor to the self weight of concrete (for cap self weight in particular)?

A few RC-PIER users recently asked questions about the two analysis options in the abutment design and the related footing design reports. Here is some clarification. In abutment design, when "Cap as continuous beam" is selected for the frame analysis…

When manually inputting live loads into RC-Pier, how do you specify a lane load. According to the help.... "For manually input live loads in AASHTO LRFD, this screen behaves slightly different. When a live load case is added in LRFD mode and edited, the…

I am designing a two stage pier wall. There is no option for just a wall in RC pier. Is there a way to trick the program, I have tried a couple of different options but none have worked. The top wall is tapered in both directions and the bottom wall does…

I cannot match the values that RC Pier generates for the column's moment magnification calculation for the Bd value (Ratio of Perm. Moment/Total Moment from AASHTO LRFD eqn 5.7.4.3-2). I have tried the minimum eccentricity from the AASHTO LFD code. I…

I'm trying to apply vertical wind loads on a pier per AASHTO LRFD 3.8.2. The problem I have is with the load combination generation. This load shoud only be applied during Strength III and Service IV limit states. Is there a way to specify this for the…

Hello all: I am having an extremely difficult time getting through my bridge design on LEAP bridge. Especially while working in GEOMATH and RC PIER. In GEOMATH: Problem #1: Back when I was trying to make minor adjustments to the geometry of the…