OpenBridge Special Interest Group: Using a BIM or Standalone Workflow in OpenBridge Designer Host: Alex Mabrich, Senior Application Engineer, Bentley Systems, Inc. Date/Time: April 7, 2020 at 2 p.m. EDT Register Now This OpenBridge…

Hi All I am modelling and designing multi column pier in Leap, But after applying loads i am getting ambiguous bending moment, also huge reinforcement is showing on designing. Please find the model attached and any one please can help and check the…

I am designing an abutment using RC Pier. Under the Loads tab, I input/generate EV & EH loads. However, when I run an analysis and review the load combinations the vertical or horizontal earth loads are all "0". It appears that these loads are being applied…

I'm desiging a pier wall with a cap on top. The wall is about 2'-6" wide and the cap is 4'-6" wide (side view). The "Wall Pier" option does not allow a cap. The "Multi-Column" option requires a minimum of two-columns. I've input two wall columns but the…

A few RC-PIER users recently asked questions about the two analysis options in the abutment design and the related footing design reports. Here is some clarification. In abutment design, when "Cap as continuous beam" is selected for the frame analysis…