Hello everyone!
Recently we are planning to replace our OpenPlant Modeler u8 with the latest version u10.
However we noticed that the workset we used in u8, WorkSpace\OpenPlantMetric, was removed from the u10 install package. We have many important…
Hi All,
How can we change the default Raceway configuration?
We want to change it in the managed workspace, so all users when they create a new drawing in ProjectWise, have the same configuration (1 Cable basket, with catalog and UDA pre-set).
Where…
I am getting an error while trying to use an MDL custom functionality. Please find the attached image below:
I am using OpenPlant V8i SS6 along with ProjectWise Explorer Connection Edition 329. We have setup this in our workspace. I have tried to…
Applies To
OpenPlant Suite of Products
Product(s):
OpenPlant Project Administrator CE
Version(s):
10.07.00.32 (CONNECT Edition)
Environment:
Windows 7/8.1/10 (64 bit)
Area:
WorkSpace
Subarea:
Activation
…
OpenPlant and CONNECT Services – a great combination to help you work smarter and make the most of your software investment. Learn more at the next OpenPlant Special Interest (SIG) virtual workshop on Thursday, February 22, 2018 at 10:30 a.m. EST. Register…
We are working on implementing the following products from OP suite, File Based
We would prefer an integrated WorkSpace for all modules
Have integrated OPM, OPIM & OPSE
Currently working on integrating OPOM.
Is this a good Idea, or should it be…
Hello Tuan,
You can check below wiki as well where whole workspace can be shared through network drive.
http://communities.bentley.com/products/plant/design___engineering/w/plant_design_and_engineering__wiki/28289.how-to-configure-openplant-modeler…
Hi Colin,
Please refer below wiki article for sharing the OpenPlant Modeler workspace on network drive.
http://communities.bentley.com/products/plant/design___engineering/w/plant_design_and_engineering__wiki/28289.how-to-configure-openplant-modeler…
Hi Craig,
Please check the registry. Go to HKEY_LOCAL_MACHINE\SOFTWARE\Wow6432Node\Bentley\OpenPlantModeler\{FEBA3E9F-10EE-4C2D-B863-712CA4416C32} and check if you see Workspace Path pointing to correct location.
Regards, Harpreet