maximum number of vertices in profile in ORD?
Hello-
I am experiencing weirdness with my alignment/profile in OpenRoads Designer 2021 R1.
I have a 3 mile trail with many horizontal and vertical curves. I know there may have been limitations with Geopak/V8i with the number of vertices in a profile…
Why do my VPI disappear when I view profile model an edited and imported profile? - Inroads SS4
I have created a vertical alignment using the complex by VPI tool. I have since set active, and saved my alignment to my .alg and .rwk.
Later, I use Evaluation -> Profile -> Create Profile, and plot my vertical alignment. I then use Geometry -> Vertical…
Openroads - Create Profile From Text
As my company transitions from Geopak to Openroads, we are figuring out how to do everything in Openroads that we could in Geopak. In Geopak we were able to create a profile from text using the Geopak Cogo Command Editor and then using the Design and…
Insert PI into Civil Geometry
Product(s):
OpenRoads Designer
Version(s):
10.00.00.120+
Area:
Geometry
Original Author:
Holly Herring, Bentley Technical Support Group
Question:
How do you insert a PI into horizontal/vertical geometry in OpenRoads…
Delete PI in OpenRoads Designer
Product(s):
OpenRoads Designer
Version(s):
10.00.00.120+
Area:
Geometry
Original Author:
Holly Herring, Bentley Technical Support Group
Question:
How do you delete a PI (horizontal or vertical) in OpenRoads Designer…
Delete PI in OpenRoads (SS4)
Product(s):
InRoads, MX, GEOPAK
Version(s):
08.11.09+
Area:
General Geometry
Question:
How do you delete a PI (horizontal or vertical) in OpenRoads?
Answer:
OpenRoads Geometry does not have a "Delete PI" command. Instead…
How to add a Curve to a Complex by VPI Vertical Profile
Applies To
Product(s):
MXROAD, InRoads, GEOPAK
Version(s):
08.11.09.493
Environment:
N/A
Area:
Vertical Geometry
Subarea:
Complex Vertical Profile
Original Author:
Jason…
Re: SS3 Adding curves to profile
When using the Profile Complex by VPI tool you can set a radius in the Complex Element by VPI Panel.
You set the curve to a small value and when you have laid out the full length of the profile you can update the curve value to what you require…