I have a proposed vertical alignment that seems to revert itself back to a Construction Class even after changing it to Primary. Any thoughts on why or tips to fix this issue?

I requested additional survey to be done for me project. The surveyor added the csv data into the field book for my terrain file. This caused my current vertical profile to be dramatically shifted from where it should have been. Is there a way to avoid…

So this is more of a commentary rather than a question. we are still new to ORD and ran into the issues of wanting the detour vertical and mainline vertical to show on the same profile. Projected profiles are obviously not sufficient as they truncate…

3618.test10.dgn Attached is an intersection drawing I am working in (working in 2D view). I need to extract vertical profile information from particular lines of a linear template tied to an alignment that has an active profile associated with it. If…

I have a completed profile that I'm trying to go back and modify the vertical slope in one area. I want to break that slope into 2 different slopes and place some other vertical geometry between them. The beginning and end of the current slop is related…

ORD 2021R1 Update 1 (10.10.01.03) I'm having an issue with element profiles, in this case projecting to the offside edge of a diverge nose (highlighted). The mainline channel is profiled using 0% from the corridor element, its profile is on the left…

I'm having trouble updating my profile annotation for side streets within my project. The issue I'm having is the annotation isn't showing any values and the points don't seem to show up in the right spot. It seems as if the profile reports show all of…

I'm using Power Geopak V8i SS10. Very new user. I have my vertical alignment built and I built using line and then profile curve between element. I noticed that PI location is determined by the lines, as that is the way that I built it. I'd like to…

I keep loosing Vertical profiles in ORD 2020R3. My work flow is as follows- I will draw the vertical profile by tracing my active terrain, (snapping to it I believe) I will complex it, set it active and move on, removing the active terrain, and everything…

I'm trying to create a graded area around a pad. I create the horizontal geometry (square) and then use Complex Geometry to unify the lines into a single element. I create the concrete pad first, without issues, and the vertical profile is generated again…

I am using Bentley PowerGeopak SS4. I am trying to store a vertical profile in COGO using the road tool "Geopak-Road-Geometry-Layout (Component Based)". I have active chain control open and COGO activated, however I am unable to draw any of the profile…

Hello everyone! I am using MX Roads V8i SS4 version with windows 10. How do I associate a Triangulation model (of a cross road) other than my main ground Tria? While trying to associate it the usual way, it does not show any drop down menu (in …

I have created an overpass profile in PowerGeopak SS4 V08.11.09.904(Figure 1) but encountered an issue when trying to import it in Openroads Designer V10.06.00.38(Figure 3). When imported in Openroads Designer, it create a tangent line from PI of Sag…

Hi guys, Creating my vertical profile i'm trying to show the intersections where the secondary intersects with the primary road. How should i do this? The vertical profile for the primary road is shown below. Kind regards

Hello, I'm trying to figure out how to insert breakpoints into the vertical profile of a line built by a civil cell. I'm laying out the edge of lane for a sideroad intersection that tapers from a matchline on the sideroad to the mainline edge of pavement…

Hello, I'm trying to do something that should be relatively simple, but there doesn't seem to be a tool or workflow to get it done in Microstation. Specifically, I want to project two vertical profiles onto a particular element such that it's vertical…

Hello, I got a question/problem concerning Quick Alignment option. In designing a Vertical Profile MX doesn't lock radius of vertical curves while moving IP. I've chosen a radio button for radius locking but it isn't working - radiuses are changing…