Cross Sections surface issues.
Hi,
I have been trying to export XS from my model and I seem to run into 2 problems:
1. I cannot figure out how to display the existing surface only per station rather than the full 3D surface model. Inside the red box you can see the template drop…
ORD - Cross sections sheets
How can you control the spacing between cross sections on a sheet in ORD ?
XS Profile Grade Report
Applies To
Product(s):
GEOPAK Road PowerCivil Site
Version(s):
SS2
Environment:
N/A
Area:
N/A
Subarea:
N/A
Original Author:
Bentley Technical Support Group
…
Slope/End Condition lines in XS
The slope/end condition lines are not showing up when I create cross sections. The lines show up in the corridor, 3d model and dynamic cross sections.
The screen shot below shows the points of the ditch bottom and where the back slope meets existing;…
Runtime Error 91 when running Cross Section Labeler
Applies To
Product(s):
Bentley GEOPAK Civil Engineering Suite
Version(s):
08.11.07.615
Environment:
N/A
Area:
Corridor Modeler Cross Section Labeler
Subarea:
Original…
XS Sheets Clipping Wrong
Applies To
Product(s):
Bentley GEOPAK Civil Engineering Suite
Version(s):
08.11.07.615
Environment:
N/A
Area:
Road > Cross Sections > Cross Section Sheet Composition
Subarea:
…