• Modules (i.e. Flange Analysis, Spring Hanger Selection, Rotating Equip, TTA) in AutoPIPE
    Mike Dattilio
    Flange Analysis Rotating Equipment Thermal Transient Analysis (TTA) Spring Hanger Selection Model Explorer See Also __Table Of Contents - AutoPIPE Wiki page Bentley A...
  • Flange Analysis - AutoPIPE
    Tanaji Gaikwad
    The Result > Flange > Flange Check command will display the Flange Analysis dialog, enabling the user to apply several different flange analysis methods on every flange in the model. Standard flange data...
  • Can Autopipe Vessel calculate ASME flanges according Appendix Y?
    Zvonimir Opic
    I need to perform ASME VIII, Division 1, Appendix Y, Class 1, Category 1.1 flange calculation. Can it be done in Autopipe Vessels? If yes - how? If not -> why?
  • The loads in hanger report are not matching with the forces from analysis. I have attached snaps for both report.
    PRASAD PUJARI
    Refer to node 630. The Fy from forces report is 2807N for case GT2(2). However, the hanger selection considers the load as 5320.2N. Is it not the hanger shall be selected for load 2807N?
  • Q. Modeling flanges as one point does it affect the flange leakage calculation?
    Tanaji Gaikwad
    Applies To Product(s): AutoPIPE Version(s): ALL Area: Flange Analysis Date Logged & Current Version Nov 2023 23.00.00.230 Problem: Modeling flanges as one point...