• 02. Why does a BEW heat exchanger designed to CODAP 2005 not calculate to ยง C7.A9.6 (sliding head exchanger)?
    Tanaji Gaikwad
    AutoPIPE Vessel team decided to not apply the Annex C7.A9 for sliding tubesheet because this chapter is not sufficient. There is no rule to determine the thickness of the tubesheet, so we decided to...
  • System Messages
    Mike Dattilio
    Application Crash AutoPIPE Vessel Design and Calculations Error Intel(r) Visual Fortran run-time error Licensing Prodia2 Prodia2.exe Setup Warning
  • Error Messages
    Tanaji Gaikwad
    Error Code 032768 - Program has encountered an error and will close now Error Code 25 - Insufficient strength in shell/channel joint Error Code 27 - Longitudinal membrane stress in the tubes exceeded...
  • "Note" Messages in AutoPIPE
    Mike Dattilio
    Material warnings for low temperature properties have been suppressed N13-61: Code material cold and hot properties are updated N13-83: Pressure extension has been enabled in the analysis ...
  • Application Crash Messages
    Mike Dattilio
    Why / When the application crashed: Running Strength calculations Running Strength Calculation on a tall column with trays While modifying lateral support above 2100 inches from ground on a vertical...