• Q. Why does AutoPIPE Vessel crash when executing calculation on a tall column with trays?
    Mike Dattilio
    Applies To Product(s): AutoPIPE Vessel Version(s): ALL Area: Crashed Date Logged & Current Version June 2018 40.06.00.07 Problem: Why does program crash when...
  • 06. The Calculation Strength command or button is grayed out, How to resolve this in AutoPIPE Vessel?
    Tanaji Gaikwad
    The Calculation Strength command is grayed out: The Calculation Strength button is grayed out: Answer: There are 2 issue that would cause this to happen: 1. Running in Demo Mode or with out...
  • 07. Error in the calculation of yC: yC = m + E + m + H/2 in the edition of the results
    Tanaji Gaikwad
    Answer: There would be the error in calculation of yC because there is no weld at the top of the sail.
  • Q. Why are some models (ex.QA 262-6.dat) are not listed in the Test Set Execution Status Matrix of the AutoPIPE ATS document (ap_ats.pdf)?
    Mike Dattilio
    Answer: In the AutoPIPE ATS document (ap_ats.pdf), just before "Description of Acceptance Test Systems", is a note that reads" " * These test sets are not part of the published Acceptance Test Set...
  • Calculations
    Tanaji Gaikwad
    A. As Per BS EN 13445-3 B. As Per ASME Section VIII C. As Per CODAP D. PD 5500 E. AD 2000-Merkblatter F. General See Also Bentley AutoPIPE Vessel Support Solutions & FAQ's