• 01. PCF Translator FAQ & troubleshooting - AutoPIPE
    Shrey Sharma
    Comments, Questions, and Answers with PCF translator into AutoPIPE: Note: 1. See PCF translator Help / manual for complete details 2. How to create a PCF file - click here 0: Install PCF translator...
  • 05. Additional details regarding PCF Translator's tabs in AutoPIPE
    Mike Dattilio
    Model Component Coordinates Support Gaps Defaults Attribute Mapping See Also AutoPIPE Translators Bentley AutoPIPE
  • 02. Additional details regarding the PCF Translator's "Component" tab in AutoPIPE
    Mike Dattilio
    When importing a PCF file there are additional settings that can be used to successfully convert a PCF file into a NTL file that can then be opened by AutoPIPE. These additional settings can be found on...
  • 04. Additional details regarding the PCF Translator's "Support Gaps Defaults" tab in AutoPIPE
    Mike Dattilio
    Questions: Q1. Where are these settings stored? Answer: PCFin.MAP file, shown below.
  • Hi everyone! I'm importing a autocad plant 3D PCF to autopipe, but two 45 degree bends is disconnect and out of the segments. I can't connect the segment. The lost curves of the segment appear far away...
    Ana  Cruz