Water Loads in PLAXIS 3D

Hi I am modelling jack-up leg extraction in PLAXIS 3D. I have modelled a quarter of the model since it is symmetric. The groundwater boundary within PLAXIS is set as per the snapshot showed below. When...
rename custom water level

How can we rename custom water level in PLaxis 3D?
Strange behavior or pore water pressure

Hello, I'm trying to model an excavation in an axisymmetric 2D model. Water pressure was defined in a particular way at the initial phase where the bottom soil layer was set to dry and the layer just...
Draw water table in Plaxis 3D

Hi all, Can anyone tell how to draw the water table for this following cases using points? Thanks.
Default value of the water bulk modulus

Dear All, I have a short question on the water bulk modulus when choosing calculation of excess pore pressure from the Biot's equations. I have noticed that the default value of Kw is 500MPa, which is...