LEAP Bridge Concrete: Prestressed Box Beam End Block

Hello, I am using LEAP Bridge Concrete CE V21.02.00.38. I have an end block (solid section of box) for 2' at each end of my prestressed box beams. This will add quite a bit of Vc capacity. Is there a...
In LEAP Bridge Concrete can you consider bonded prestressing strands as “Reinforcement” when determining allowable tension stresses in a precast concrete beam?

I am using AASHTO LRFD and IDOT does not have conventional longitudinal reinforcing in their PPC IL-Beams, but IDOT does consider bonded prestressing strands as sufficient in resisting the temporary tensile...
LARS | LEAP | OpenBridge | OpenTunnel | RM

This is the Main Page of a series of Wiki articles on the Be Communities page for OpenBridge and OpenTunnel engineering software solutions from Bentley Systems Inc . OBD - OpenBridge Designer OTD - OpenTunnel...
Leap bridge concrete Flexure check

Hi If we define bar length, is leap bridge software have capability to deduct development length based on dia of bar and calculate flexure check at that point.
Overstress factors not applied to column in LEAP Concrete?

Hi there, I am checking column capacity in LEAP Bridge CE V20. The default load combinations I am using are correctly applying the overstress factor (See below screenshot #1), however, the overstress...