Creating Plan Sheet and Drawings - Some slower than others?

I have a 20 mile project split into 6 separate alignments/corridors of roughly the same length (3.33 miles) to make it as manageable as possible. None of the corridor sections are anymore complex than...
Plan By 3D Element Tool inccorect result

Hello colleagues. I have a problem using the toolkit : Plan By 3D Element. As a result of using the tool, a line is obtained that differs from the original one that was created in Autocad, namely,...
Printing plan sheets and profile sheets are all off scale and elevations are off aswell.

I am student who currently is working on their senior project. I have been using openRoads since August most has been a breeze till printing. All of my work is done but whenever I try to make cross section...
How to resolve "No Design Surfaces Found" message and create cut fill volumes

Product(s): OpenRoads Designer Version(s): 10.06.00.38 Area: Analysis Question: When I use the create cut fill volume tool I get the following message: "No Design Surfaces...
How to model a thickened edge sidewalk in Open Roads designer

Hello Community, I'm fairly new to design and I have encounter this project where I am require to add a Thickened edge sidewalk. However, I do not know how to add this to my template. below is a picture...