Create bottom mesh/surface from Surface elements.

Hej I am working on a parking areal where I need to create a bottom surface. I have added to the surfaces an surface template with different depth. Wjhat Im hoping I can do is either extrude the lines...
How to resolve "No Design Surfaces Found" message and create cut fill volumes

Product(s): OpenRoads Designer Version(s): 10.06.00.38 Area: Analysis Question: When I use the create cut fill volume tool I get the following message: "No Design Surfaces...
Adding a surface to existing cross sections

I have previously cut cross sections that show my roadway but have since created two other surfaces/terrains that I want to display in the previous cut sections since I have done some annotating on them...
modeling issue with project to surface constraint

The pavement component is not drawing correctly. The top left is projected to surface-up. The top of the component is supposed to connect straight and not follow the existing ground as it is doing in the...
projected slope stops updating after adding surface profile

Hi all, I want to design my vertical alignement for the highlighted arc (cyan). When I project the main profile (red alignment) onto this cyan arc this is dynamic, i.e. when I change the horizontal radius...