Where can I find/create this node

When I create a pipe from a 2D line, OpenRoads automatically adds these nodes to the end point of the line. I want to use this node for all my pipes that I end up manually drawing in by first placing nodes...
How to place a conduit for a Storm Sewer Outlet pipe from a Node to a Daylight Condition?

We need to create an existing subsurface utility 3D model. How do I layout a simple storm pipe from a node (manhole/inlet) to the daylight condition (or to an open field) which may or maynot have end section...
Cross section

Hi, I have a challenge that my cross sections printed to pdf in ORD 2022 Release 3 display the end conditions hanging in space or passing through the existing ground yet in the dynamic cross sections...
Cross Section Annotation Filter

I want to set up an annotation definition to apply an elevation annotation on the lower of two points (As shown below). I've tried applying different variations of the annotation filter shown below...
Named boundaries for cross sections

I am trying to create a cross section drawing that has 3 cross sections per sheet. However, due to some apparent factors I am unaware of, some sheets only display 1 section. I am assuming this is due to...