Applies To
Product(s):
AutoPIPE Vessel
Version(s):
ALL
Area:
General FAQ
Date Logged & Current Version
March 2019 41.00.00.006
Problem:
In AutoPIPE Vessel's cost estimate module, when I enter an hourly rate…
Answer:
The rates in AutoPIPE Vessel cost estimation module can be changed as follows:
Click on the "Customizable Files Management" icon and click "OK" then go to the tab "Rate and Time" and select the item at the list on the right and then change…
Answer:
This is a problem with your original model file (.emvd file). Check the model, check if the chamber number is correct under all the components' Material tab eg. for a single chamber vessel the chamber numbers should be 1 for all components.…
Answer:
There are 2 options to create a new cost estimation project in AutoPIPE Vessel:
1. Create from scratch
2. Use an existing .emvd model file that you have already created - in this case the items tag numbers and the geometry information are…
Answer:
Yes, it does matter what units are used.
If an AutoPIPE Vessel model (.emvd file) was created using SI unit, then the cost estimation should also be performed using SI units,
Under cost estimation module, go to:
File>Preference>Estimate…