• 04. How do you enter f1 and f2 for cone calculations in ASME VIII mandatory appendix 1-5?

    Tanaji Gaikwad
    Tanaji Gaikwad
    There is no way to apply a value for f1 and f2, these values are calculated by the program when there is a support (e.g. Legs).
    • 2 months ago
    • AutoPIPE
    • AutoPIPE Wiki
  • 21. How AutoPipe vessel takes care of Saddle if its placed on Transition element like Cone?

    Tanaji Gaikwad
    Tanaji Gaikwad
    Answer: The diameter at the cone location where the saddle is attached is considered for the analysis, the calculation procedure is same as that of a saddle attached to a regular shell component. The various stresses are affected depending on where…
    • 2 months ago
    • AutoPIPE
    • AutoPIPE Wiki
  • Error Code 677 - Conical Shell (XX.XX.XX) Under Internal Pressure: U-2(g) analysis is required or provide a flare at the small junction of the conical shell (Appendix 1-5(e))

    JamieP
    JamieP
    This error manifests when there is not a flare (or knuckle) on the conical shell. You can leave the design as is and use a certified inspector to verify your design as per U-2(g) or you can add a knuckle and the error will go away.
    • over 3 years ago
    • AutoPIPE
    • AutoPIPE Wiki
  • 12. How to model a nozzle attached directly to cone small diameter end?

    Mike Dattilio
    Mike Dattilio
    Applies To Product(s): AutoPIPE Vessel Version(s): Connect Edition Area: Modeling Original Author: Bentley Technical Support Group Date Logged & Current Version Mar. 2019 41.00.00.006 …
    • 11 months ago
    • AutoPIPE
    • AutoPIPE Wiki
  • Error Code 181 - Cone 3: should be placed between 2 shells

    JamieP
    JamieP
    Applies To Product(s): AutoPIPE Vessel Version(s): V8i Environment: N/A Original Author: Bentley Technical Support Group Date Logged & Current Version Dec. 2016 40.02.00.08 Problem: The following message…
    • over 3 years ago
    • AutoPIPE
    • AutoPIPE Wiki
  • View related content throughout AutoPIPE
  • More
  • Cancel