• 12. Pressure consideration for DNV limits (as both internal and external pressure considered) v/s stress design “ASDC” (only internal pressure considered as differential) in AutoPIPE?

    Mike Dattilio
    Mike Dattilio
    Applies To Product(s): AutoPIPE Version(s): ALL; Area: Results Date Logged & Current Version Feb. 2019 12.00.00.14 Problem: Pressure consideration for DNV limits (as both internal and external pressure considered…
    • over 4 years ago
    • AutoPIPE
    • AutoPIPE Wiki
  • 07. Is AutoPIPE suitable for deep offshore analysis as regard to calculating true pipe wall force which will take into consideration the end cap effect and external pressure?

    Mike Dattilio
    Mike Dattilio
    Applies To Product(s): AutoPIPE Version(s): ALL; Area: Modeling Original Author: Bentley Technical Support Group Date Logged & Current Version Dec. 2016 10.01.00.09 Problem: Is AutoPIPE suitable for…
    • over 4 years ago
    • AutoPIPE
    • AutoPIPE Wiki
  • 06. Does AutoPIPE consider external pressure or temperature for underwater / subsea piping?

    Mike Dattilio
    Mike Dattilio
    Applies To Product(s): AutoPIPE Version(s): ALL; Environment: N/A Area: Modeling Original Author: Bentley Technical Support Group Date Logged & Current Version Dec. 2016 10.01.00.09 Problem: …
    • over 1 year ago
    • AutoPIPE
    • AutoPIPE Wiki
  • 01. Is the role of jacket half coil considered for external pressure design?

    JamieP
    JamieP
    Applies To Product(s): AutoPIPE Vessel Version(s): ALL Area: Modeling Date Logged & Current Version July 2018 40.06.00.07 Problem: Is the role of jacket half coil considered for external pressure design? Solution…
    • over 3 years ago
    • AutoPIPE
    • AutoPIPE Wiki
  • 05. What value for overpressure need to be entered for blast load condition in AutoPIPE Vessel?

    JamieP
    JamieP
    Answer: This is the value which allows the user to obtain in the calculation as an external pressure the value equal to the overpressure minus the internal pressure of the vessel. For example: Overpressure = 50 MPa; Internal pressure of the…
    • over 3 years ago
    • AutoPIPE
    • AutoPIPE Wiki
  • 03. How do I control whether or not use stiffener for external pressure?

    JamieP
    JamieP
    Answer: Under Vessel Properties>Design Parameters tab, the user can check or uncheck the option as shown below to design with or without stiffener for external pressure. Also the option of including the inertia of associated shell for external pressure…
    • over 3 years ago
    • AutoPIPE
    • AutoPIPE Wiki
  • 02. Does AutoPIPE Vessel consider cone-shell junction as line of support for external pressure calculation?

    JamieP
    JamieP
    Answer: Yes, AutoPIPE Vessel automatically considers the cone-shell junction as line of support for external pressure calculations. If the junction is not sufficient then a stiffener is automatically added. This is clearly printed out in the report…
    • over 3 years ago
    • AutoPIPE
    • AutoPIPE Wiki
  • View related content throughout AutoPIPE
  • More
  • Cancel