• 35. How does one model supporting an inner vessel from an outer vessel in AutoPIPE Vessel?

    JamieP
    JamieP
    Answer: This can be done using a jacketed vessel design module that exists in AutoPIPE Vessel. Vacuum pressure can be applied as ‘0’ external pressure on the inner vessel (chamber 2) and as ‘0’ internal design pressure for the outer vacuum chamber…
    • over 3 years ago
    • AutoPIPE
    • AutoPIPE Wiki
  • 02. How to import Aspentech edr file into AutoPIPE Vessel?

    JamieP
    JamieP
    Answer: Please follow the steps below: step 1: step 2: step 3: step 4: step 5: Click OK to generate the exchanger model.
    • over 3 years ago
    • AutoPIPE
    • AutoPIPE Wiki
  • 01. When choosing a 8" nominal shell size the O.D. is reflected as 8.78" O.D. (it should be 8.625").

    JamieP
    JamieP
    Answer: That seems normal, taking into account that your heat exchanger is requested to use the internal diameter (see general geometry dialog) The input for the shell is 8 inch NPS Normally an 8 inch NPS pipe has an external diameter of 8.625…
    • over 3 years ago
    • AutoPIPE
    • AutoPIPE Wiki
  • Shell and Tube Heat Exchangers

    Tanaji Gaikwad
    Tanaji Gaikwad
    01. When choosing a 8" nominal shell size the O.D. is reflected as 8.78" O.D. (it should be 8.625"). 02. How to import Aspentech edr file into AutoPIPE Vessel? 03. For a shell and tube exchanger with fixed tubesheets, the AutoPIPE Vessel is locked…
    • 3 months ago
    • AutoPIPE
    • AutoPIPE Wiki
  • View related content throughout AutoPIPE
  • More
  • Cancel