• 15. How do I analyze a rectangular vessel attachment or wear plate?

    Tanaji Gaikwad
    Tanaji Gaikwad
    In order to analyze for a vessel attachment, you will need to run a local load analysis in the component design module.
    • 2 months ago
    • AutoPIPE
    • AutoPIPE Wiki
  • 26. Nozzle local Load - at which point is it applied?

    JamieP
    JamieP
    Answer: The nozzle local load is applied at the nozzle to shell junction for the calculation since ultimately the intent is to calculate the stress on the shell due to the load on the nozzle. The load is NOT applied at the nozzle tip so please calculate…
    • over 3 years ago
    • AutoPIPE
    • AutoPIPE Wiki
  • Error Code 52 - WRC 107-297: Local Load Error

    JamieP
    JamieP
    WRC local load analysis method is based off of analytical and experimental data and is only applicable for certain specific range of the ratios of the geometric parameters of the vessel eg. vessel wall thickness, nozzle thickness, nozzle diameter and…
    • over 3 years ago
    • AutoPIPE
    • AutoPIPE Wiki
  • 10. How is the nozzle fillet radius calculated for WRC calculations in AutoPIPE Vessel?

    JamieP
    JamieP
    Applies To Product(s): AutoPIPE Vessel Version(s): V8i Area: Modeling Original Author: Bentley Technical Support Group Date Logged & Current Version Mar. 2015 33.02.02.04 Problem…
    • over 3 years ago
    • AutoPIPE
    • AutoPIPE Wiki
  • View related content throughout AutoPIPE
  • More
  • Cancel