In OBD CE 2021 Release 2 and RM Bridge v11.13, was implemented transfer tendon points to all beams in one unique deck cross-section. When transferring OBM model to RM, for analysis, the User can choose the option "Transfer all beams inside one deck…

Question How are elastic compression losses in tendons due to initial pre-stressing and subsequent loads handled in RM Bridge? Where can I see the results, in particular due to stressing of other tendons and due to time-dependent effects of creep, shrinkage…

New schedule action for plotting ultimate bending capacity in the cross-section for load cases and envelopes is now available. Users can now plot the list files results (.lst) and will be able to quickly check if the ultimate capacity is achieved in the…

A new option in the “Cross section point selection” dialog, under Tendon in the RM Modeler, which allow Users to generate the same tendon geometry for all other points inside of the grid pint group is now available.

RM > Modeler > Tendons > Geometry “Internal” Tendons = post-tensioned tendons. “Master” Profile = for the whole superstructure and to assign this geometry to different tendons stressed in different construction stage. (Tnds100,110,200,210,300,310…

Inside RM Bridge CONNECT Edition there is an option called New Cantilever Wizard that can be found at Extras/Preprocessors/Cantilever/Cantilever Wizard (New). . It is a GUI - Graphical User Interface - that is much more user-friendly and was recently…