In OBD CE 2021 Release 2 and RM Bridge v11.13, was implemented transfer tendon points to all beams in one unique deck cross-section. When transferring OBM model to RM, for analysis, the User can choose the option "Transfer all beams inside one deck…

New schedule action for plotting ultimate bending capacity in the cross-section for load cases and envelopes is now available. Users can now plot the list files results (.lst) and will be able to quickly check if the ultimate capacity is achieved in the…

A new option in the “Cross section point selection” dialog, under Tendon in the RM Modeler, which allow Users to generate the same tendon geometry for all other points inside of the grid pint group is now available.

RM > File > Read TCL Data Schedule Actions for construction stages, additional and traffic load cases, load combinations, check actions… Loads Definition with combination table, load management, load sets and load cases. Traffic Lanes and Load Trains…

RM > Modeler > Tendons > Geometry “Internal” Tendons = post-tensioned tendons. “Master” Profile = for the whole superstructure and to assign this geometry to different tendons stressed in different construction stage. (Tnds100,110,200,210,300,310…

Inside File\Examples\Demo Examples & FAQ user will find the Frequently Asked Questions and Solutions section for RM Bridge Enterprise . As shown in the screenshot below, user can select the T-beam model as a reference entitled Concrete Structures - Ultimate…

Inside File\Examples\Demo Examples & FAQ users will find the Frequently Asked Questions and Solutions section for RM Bridge Enterprise . There the user can select the T-beam model as a reference entitled Two-span Composite Bridge Concrete/Concrete . There…

Inside RM Bridge CONNECT Edition there is an option called New Cantilever Wizard that can be found at Extras/Preprocessors/Cantilever/Cantilever Wizard (New). . It is a GUI - Graphical User Interface - that is much more user-friendly and was recently…